Render Water Repellent is a water based sealer suitable for all cement based renders, it penetrates into the body of the render and once dry it provides a waterproof zone where moisture can not penetrate. By reducing water penetration it stops efflorescence and water-borne staining and significantly increases the life of paints & coatings.
Render Water Repellent is Non-Toxic, will not peel or blister is UV and alkali stable and under normal circumstances will not significantly alter the appearance of the rendered walls. However it is strongly recommended that a test be carried out prior to application.
Download Product Information Brochure.
Surfaces should be clean, dry, firm and free from oil or previously applied sealers or coatings. If required, surfaces can be washed with a strong detergent/degreaser and rinsed with water. Any cracked or damaged areas should be filled with cement based filler and allowed to cure & dry. Apply the product by brush, roller or airless sprayer, making sure that the surface is saturated. If solution is quickly absorbed apply a second coat at a rate that shows the product running down the surface.
Any product remaining on the surface after 5 minutes should be wiped off. (So as to not create an uneven surface) REMOVE PRODUCT FROM AREAS YOU DO NOT WISH TO TREAT IMMEDIATELY WITH A DAMP CLOTH OR SPRAY. Do not apply if rain or extreme weather conditions are expected.
Coverage rate will vary from 2-4m2 per litre/coat and always test a small area to ensure suitability of the product to your requirements. Shake/Stir well prior to use.
Water repellence in 24 hours and full cure achieved in 7 days.
- Milky white in appearance
- Solids content of < 50% by weight
- Specific gravity of 1.0 @ 20 ºC
- pH of 7 - 8
- Soluble in water
- No VOC content
- Non flammable
Eyes: Flush eyes with water for at least 15 minutes
Skin: May cause irritation, Wash affected areas with soap and water.
Inhalation: May cause irritation, Move subject to fresh air. If breathing is difficult, give oxygen.
Ingestion: Can cause gastrointestinal irritation, Give 2 glasses of water to drink to dilute.
Consult a Doctor. DO NOT INDUCE VOMITTING
Handling & Storage
Non-Hazardous according to criteria of Worksafe Australia.
The product is classified as a non-hazardous material. However, as with all chemical products good industrial hygiene procedures should be followed when using this product.
Wear suitable gloves & goggles and use in well ventilated areas.
Store in well ventilated area and keep container sealed and away from excessive heat and out of direct sunlight.
KEEP OUT OF REACH OF CHILDREN