Skip to main content



  Contact Us
   (08) 9362 5008

Product Information Brochures
more images
Render Water Repellent 20 Litres
back add to cart buy now

Render Water Repellent is a water based sealer suitable for all cement based renders, it penetrates into the body of the render and once dry it provides a waterproof zone where moisture can not penetrate. By reducing water penetration it stops efflorescence and water-borne staining and significantly increases the life of paints & coatings.

Render Water Repellent is Non-Toxic, will not peel or blister is UV and alkali stable and under normal circumstances will not significantly alter the appearance of the rendered walls. However it is strongly recommended that a test be carried out prior to application.

Download Product Information Brochure.

Surfaces should be clean, dry, firm and free from oil or previously applied sealers or coatings. If required, surfaces can be washed with a strong detergent/degreaser and rinsed with water. Any cracked or damaged areas should be filled with cement based filler and allowed to cure & dry. Apply the product by brush, roller or airless sprayer, making sure that the surface is saturated. If solution is quickly absorbed apply a second coat at a rate that shows the product running down the surface.

Any product remaining on the surface after 5 minutes should be wiped off. (So as to not create an uneven surface) REMOVE PRODUCT FROM AREAS YOU DO NOT WISH TO TREAT IMMEDIATELY WITH A DAMP CLOTH OR SPRAY. Do not apply if rain or extreme weather conditions are expected.

Coverage rate will vary from 2-4m2 per litre/coat and always test a small area to ensure suitability of the product to your requirements. Shake/Stir well prior to use.

Water repellence in 24 hours and full cure achieved in 7 days.

Physical Data 
- Milky white in appearance
- Solids content of < 50% by weight
- Specific gravity of 1.0 @ 20 ºC
- pH of 7 - 8
- Soluble in water
- No VOC content
- Non flammable 

First Aid

Eyes: Flush eyes with water for at least 15 minutes
Skin: May cause irritation, Wash affected areas with soap and water.
Inhalation: May cause irritation, Move subject to fresh air. If breathing is difficult, give oxygen.
Ingestion: Can cause gastrointestinal irritation, Give 2 glasses of water to drink to dilute.
               Consult a Doctor. DO NOT INDUCE VOMITTING

Handling & Storage

Non-Hazardous according to criteria of Worksafe Australia.
The product is classified as a non-hazardous material. However, as with all chemical products good industrial hygiene procedures should be followed when using this product.
Wear suitable gloves & goggles and use in well ventilated areas.
Store in well ventilated area and keep container sealed and away from excessive heat and out of direct sunlight.

add to cart buy now

    Home   About Us   Products   Delivery and Returns   Waterproofing   Sealers   Home Maintenance Blog   Brochures   Site Map   Privacy Policy   Contact

    Steinwerk Solutions | | Ph: (08) 9362 5008 | Fax (08) 9362 6001
    SiteFresh Web Design | Copyright © 2012 Steinwerk Solutions. All Rights Reserved.