Admixture for the repair, colouring and waterproofing of grout in all areas.
When used as a direct replacement for water in tile grouts it greatly increases adhesion of the grout to all clean surfaces (including the glazed face of the tile) and the grout becomes waterproof once cured (after 24 hrs).
Mixed with grout to paint like consistency and brushed on to existing grout it will fill, colour and waterproof hairline cracks.
Grout Bond & Seal 4 adheres to all surfaces and the longer it is left the more difficult it is to remove. For filling where cracked or loose grout has been removed first mask both sides of line required & fill. Allow grout to lose wet look & brush neat Grout Bond & Seal 4 over the grout to obtain a neat finish & then remove masking tape. When brushed on to existing grout to colour/waterproof wipe excess product off with a dry rag before it dries.
For best results, good surface preparation is essential, surfaces should be clean and free from other sealers and oil based products. Non-toxic, non-flammable, clean tools in water.
Manufactured by Steinwerk Solutions.
Eyes: Flush eyes with water for at least 15 minutes
Skin: May cause irritation, Wash affected areas with soap and water.
Inhalation: May cause irritation, dizziness, fatigue, nausea, headache. Move subject to fresh air, if breathing is difficult, give oxygen.
Ingestion: Can cause gastrointestinal irritation, nausea, vomiting and diarrhoea. Give 2 glasses of water to drink to dilute.
Consult a Doctor. DO NOT INDUCE VOMITTING.
Handling & Storage
Classified as a non-hazardous material, however as with all chemical products good industrial hygiene procedures should be followed when using this product.
Wear suitable gloves & goggles and use in well ventilated areas.
Store in well ventilated area and keep container sealed and away from excessive heat and out of direct sunlight.
KEEP OUT OF REACH OF CHILDREN