For waterproofing ceramic tile grouts and all cement based renders. Grout and Render Waterproofing Admixture is used as a direct replacement for water in ceramic tile grouts and cement based renders. Once cured all of the grout or render will be permanently waterproof. The product stops the moisture from penetrating from both the positive and negative sides and eliminates efflorescence forming on the surface.
Manufactured by Steinwerk Solutions.
Download Product Information Brochure.
The product is ready to use, diluted the waterproofing properties will be reduced. There are no preferred methods of adding the solution to the dry ingredients, add it the same as you would normally add the water component.
The product is milky white in appearance has a specific gravity of 0.99
Ph value of 7–8
Flash point of >100ºC
Solvent free aqueous solution
As raw materials and conditions vary, it is recommended that a trial should be conducted to determine the suitability of this product for the intended purpose.
Shake/Stir well prior to use. Use in well ventilated areas.
Eyes: Flush eyes with water for at least 15 minutes
Skin: May cause irritation, Wash affected areas with soap and water.
Inhalation: May cause irritation, Move subject to fresh air.
Ingestion: Adverse effects are not expected.
Handling & Storage
As with all chemical products good industrial hygiene procedures should be followed when using this product.
Wear suitable gloves and goggles and use in well ventilated areas.
Store in well ventilated area and keep container sealed and away from excessive heat and out of direct sunlight.
KEEP OUT OF REACH OF CHILDREN